INTAREA Group R. Bonica Internet-Draft HPE Updates: 4884 (if approved) X. He Intended status: Standards Track China Telecom Expires: 30 January 2026 X. Min ZTE Corporation T. Mizrahi Huawei 29 July 2025 ICMP Extension Structure Length Field draft-ietf-intarea-icmp-exten-hdr-len-04 Abstract The ICMP Extension Structure (RFC4884) does not have a length field. Therefore, unless the length of the Extension Structure can be inferred from other data in the ICMP message, the Extension Structure must be the last item in the ICMP message. This document updates RFC 4884 to define a length field for the ICMP Extension Structure. When length information is provided, receivers can use it to parse ICMP messages. Specifically, receivers can use length information to determine the offset at which the item after the ICMP Extension Structure begins. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at https://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on 30 January 2026. Copyright Notice Copyright (c) 2025 IETF Trust and the persons identified as the document authors. All rights reserved. Bonica, et al. Expires 30 January 2026 [Page 1] Internet-Draft icmp-eh-len July 2025 This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/ license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Conventions and Definitions . . . . . . . . . . . . . . . . . 3 3. The ICMP Extension Structure . . . . . . . . . . . . . . . . 3 4. Backwards Compatibility . . . . . . . . . . . . . . . . . . . 4 5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 4 6. Security Considerations . . . . . . . . . . . . . . . . . . . 4 7. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 4 8. References . . . . . . . . . . . . . . . . . . . . . . . . . 4 8.1. Normative References . . . . . . . . . . . . . . . . . . 4 8.2. Informative References . . . . . . . . . . . . . . . . . 5 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 5 1. Introduction The ICMP Extension Structure [RFC4884] does not have a length field. This means it is expected to be the last element of an ICMP message. However, there are cases where additional fields need to be inserted after the ICMP Extension Structure. For example, [I-D.ietf-intarea-rfc8335bis] enhances the PROBE utility by adding a new field to ICMP Extended Echo and ICMP Extended Echo Reply messages. To maintain compatibility with existing PROBE implementations, this new field is placed after the ICMP Extension Structure. Because the ICMP Extension Structure does not have a length field, [I-D.ietf-intarea-rfc8335bis] requires implementations to determine the length of the extension structure from the known message format and the assumption that these packets contain only a single ICMP Extension Object. This special handling for PROBE packets is not ideal. For future use, a mechanism to explicitly specify the extension structure length would be beneficial. This document adds a length field to the ICMP Extension Header. It UPDATES [RFC4884]. Bonica, et al. Expires 30 January 2026 [Page 2] Internet-Draft icmp-eh-len July 2025 2. Conventions and Definitions The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here. 3. The ICMP Extension Structure An ICMP Extension Structure contains exactly one Extension Header followed by one or more objects. The Extension Header format is defined in Section 7 of [RFC4884]. This document modifies the Extension Header format by allocating the lower 8 bits of the reserved field for a new length field. Figure 1 depicts the updated Extension Header format. 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |Version| Rsvd | Length | Checksum | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Figure 1: ICMP Extension Header As Updated By This Document Version: 4 bits. * ICMP Extension Header version number. This is version 2 as per [RFC4884]. Reserved (Rsvd): 4 bits * MUST be set to 0 by the sender and MUST be ignored by the receiver as per [RFC4884]. Length: 8 bits * This field represents the length of the ICMP Extension Structure, including all options and optional padding, but excluding the ICMP Extension Header. The length is measured in 4-byte words. Legacy implementations set this field to 0 as per section 7 of [RFC4884]. Therefore, implementation MUST NOT drop packets if this field is set to 0. Checksum: 16 bits Bonica, et al. Expires 30 January 2026 [Page 3] Internet-Draft icmp-eh-len July 2025 * As per [RFC4884], the checksum is the one's complement of the one's complement sum of the data structure, with the checksum field replaced by zero for the purpose of computing the checksum. An all-zero value means that no checksum was transmitted. See Section 5.2 of [RFC4884] for a description of how this field is used. The ICMP Extension Structure MUST be zero-padded so that it ends on a 4-byte boundary. If it does not end on a 4-byte boundary, the receiving node will parse the ICMP message incorrectly and may discard it. 4. Backwards Compatibility Legacy implementations that do not support the mechanism defined in this document set the length field to zero when sending a packet and ignore the length field in received ICMP messages. Such implementations require one of the following: * The ICMP Extension Structure MUST be the final item in the ICMP packet. * The length of the ICMP Extension Structure can be inferred from other fields in the packet (e.g., [I-D.ietf-intarea-rfc8335bis]. Currently, no mechanisms rely on the ICMP extension structure length field. Should such mechanisms be defined in the future, backward compatibility with legacy implementations should be discussed for each case. 5. IANA Considerations This document requires no IANA actions. 6. Security Considerations This document introduces no security vulnerabilities. However, it does inherit security considerations from [RFC4884]. 7. Acknowledgements Thanks to Tom Herbert, Jen Linkova, Erik Vynke and Michael Welzl for their review and helpful suggestions. 8. References 8.1. Normative References Bonica, et al. Expires 30 January 2026 [Page 4] Internet-Draft icmp-eh-len July 2025 [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, . [RFC4884] Bonica, R., Gan, D., Tappan, D., and C. Pignataro, "Extended ICMP to Support Multi-Part Messages", RFC 4884, DOI 10.17487/RFC4884, April 2007, . [RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, May 2017, . 8.2. Informative References [I-D.ietf-intarea-rfc8335bis] Fenner, B., Bonica, R., Thomas, R., Linkova, J., Lenart, C., and M. Boucadair, "PROBE: A Utility for Probing Interfaces", Work in Progress, Internet-Draft, draft-ietf- intarea-rfc8335bis-01, 21 July 2025, . Authors' Addresses Ron Bonica HPE United States of America Email: rbonica@juniper.net Xiaoming He China Telecom China Email: hexm4@chinatelecom.cn Xiao Min ZTE Corporation China Email: xiao.min2@zte.com.cn Tal Mizrahi Huawei Israel Email: tal.mizrahi.phd@gmail.com Bonica, et al. Expires 30 January 2026 [Page 5]