Operations, Administration and Maintenance (OAM) Requirements for Bit Index Explicit Replication (BIER) Layer

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶

This Internet-Draft will expire on 7 May 2026.¶

Copyright Notice

Copyright (c) 2025 IETF Trust and the persons identified as the document authors. All rights reserved.¶

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶

Table of Contents

1. Introduction

[RFC8279] specifies a Bit Index Explicit Replication (BIER) architecture and how it supports forwarding of multicast data packets.¶

This document lists the Operations, Administration, and Maintenance (OAM) requirements for the BIER layer see Section 4.2 of [RFC8279]) of the multicast domain. The list can further be used for gap analysis of available OAM tools to identify possible enhancements of existing or whether new OAM tools are required to support proactive and on-demand path monitoring and service validation.¶

2. Requirements

This section lists the requirements for OAM of the BIER layer:¶

1. The listed requirements MUST be supported with any routing underlay [RFC8279] over which the BIER layer can be realized.¶
2. It MUST be possible to initialize a BIER OAM session from any Bit-Forwarding Router (BFR) of the given BIER domain.¶
3. It SHOULD be possible to initialize a BIER OAM session from a centralized controller.¶
4. BIER OAM MUST support proactive and on-demand OAM monitoring and measurement methods.¶
5. BIER OAM MUST support downstream path continuity check. Bidirectional Forwarding Detection (BFD) [RFC8562] is an example of a protocol that monitors the continuity of a multicast distribution tree.¶
6. BIER OAM MUST support downstream performance measurement. Simple Two-way Active Measurement Protocol (STAMP) [RFC8762] is an example of a protocol that supports measurement of performance metrics, e.g., packet loss ratio, delay, and delay variation.¶
7. In the downstream direction, a BIER OAM solution MUST support transmission of the OAM packets that follow the same path and receive the same QoS treatment as the monitored BIER flow, i.e., BIER OAM packets are in-band with the monitored BIER flow, as defined in Section 1.1.1.¶
8. BIER OAM MUST support bi-directional OAM methods. Such methods MAY combine in-band monitoring or measurement in the downstream direction with out-of-band notification, as defined in Section 1.1.1, in the reverse direction (i.e., from the egress toward the ingress endpoint of the OAM test session, as in Point-to-Multipoint (p2mp) BFD with active tail [RFC9780]).¶
9. BIER OAM MUST support the ability of any BFR in the given BIER domain to monitor BFER availability proactively. The p2mp BFD with active tail support [RFC9780] is an example of a protocol that provides notifications about the loss of connectivity in a multicast distribution tree.¶
10. BIER OAM MUST support Path Maximum Transmission Unit discovery (PMTUD). The PMTUD using ICMP [RFC1191] is an example of the mechanism.¶
11. BIER OAM MUST support an RDI mechanism to notify the BFR, the source of the continuity checking by Bit-Forwarding Egress Routers (BFERs). The Diagnostic field in p2mp BFD with active tail support, as described in Section 5 of [RFC9780], is an example of the RDI mechanism.¶
12. BIER OAM MUST support active and passive performance measurement methods [RFC7799].¶
13. BIER OAM MUST support downstream performance measurement method(s) that (together) calculate performance metrics, e.g., throughput, loss, delay, and delay variation metrics [RFC6374]. STAMP ([RFC8762] and [RFC8972]) is an example of an active performance measurement method of performance metrics that may be applied in a BIER domain. The Alternate Marking Method, described in [RFC9341] and [RFC9342], is an example of a hybrid measurement method ([RFC7799]) that may be applied in a BIER domain.¶
14. BIER OAM MUST support defect notification mechanism(s). Alarm Indication Signal [RFC6427] is an example of the defect notification mechanism.¶
15. BIER OAM MUST support a way for any BFR in the given BIER domain to originate a fault management message addressed to any subset of BFRs within the domain. [RFC6427] provides an example of a Fault Management messaging mechanism.¶
16. BIER OAM MUST support methods to enable the survivability of a BIER layer. Protection switching and restoration are examples of survivability methods.¶

3. IANA Considerations

This document does not propose any IANA consideration. This section may be removed.¶

4. Security Considerations

This document lists the OAM requirements for a BIER-enabled domain and thus inherits the security considerations discussed in [RFC8279] and [RFC8296]. Another general security aspect results from using active OAM protocols ([RFC7799]) in a multicast network.¶

Active OAM protocols inject specially constructed test packets. Some active OAM protocols are based on the echo request/reply principle of using those test packets. In the multicast network, test packets are replicated as data packets, thus creating a possible amplification effect of multiple echo replies being transmitted to the sender of the echo request. Thus, following security-related requirements for BIER OAM:¶

• A BIER OAM solution MUST protect the control plane by controlling the rate of echo request transmission.¶
• A BIER OAM solution MUST provide control of the number of BIER OAM messages sent to the control plane.¶

5. Acknowledgements

The authors would like to thank the comments and suggestions from Gunter van de Velde that helped improve this document.¶

Contributors' Addresses

Authors' Addresses